QuantumsOptimizations 预览图

杀戮尖塔 2 (Slay the Spire 2)

QuantumsOptimizations

最后更新 2026/11/22文件 5.8 MBID 3843466765

最新上传内容,不检查游戏版本兼容性。

模组简介

Client Side Mod: Does Not Affect Multiplayer Quantum's Optimizations Makes Slay the Spire 2 run smoother in busy fights, especially multiplayer with lots of mods. Results Busy test fight, 29 mods installed, measured on the host, averaged over several runs. These tests were run with HyperSpeed installed. HyperSpeed shrinks animation time, so the game engine and the less lag-friendly mods get pushed to their limits and become the bottleneck. That makes FPS worse than in normal play, since the game is skipping animations and running 10x faster. 4 players 6 players Average FPS 20 → 52 10 → 35 1% low FPS 2.1 → 4.1 1.4 → 3.4 Worst 100 frames (average) 134 ms → 77 ms 219 ms → 127 ms Time below 30 FPS per fight 22.4 s → 9.4 s 49 s → 27 s Optimizations Base game • Fight snapshot: After every action in multiplayer, the game takes a snapshot of the whole fight to check all players are in sync. For every card in every pile it asked every power, relic and card in the fight about that card's cost and keywords, rebuilding that list each time. Now the list is built once per snapshot, and only things that can change a cost or keyword get asked. • Hand redraw: Whenever anything changes in a fight, your hand redraws every card (cost, playable, keywords, glow). Each card rebuilt the full list of everything in the fight. Now the whole redraw shares one list. • Enemy intent damage: Each enemy's attack intent worked out its damage three times per redraw. Now once. • Putting cards away: When a card leaves the screen, the game unhooks it by first building a description of every signal the card has. Now it reads just the signal names. • Damage numbers: Every damage calculation walked the full list of powers, relics and cards four times. Damage shown on screen does this too: intent icons, poison previews on health bars, incoming-damage totals. Now each calculation builds the list once, and each screen refresh shares one list across all its numbers. Mods Only active if you have that mod. • RitsuLib: RitsuLib adds an extra check to the list of every power, relic and card in the fight. While nothing in the fight uses it, the check is skipped. When it's needed, it runs faster. • RitsuLib + ZoneTheSpire: ZoneTheSpire wraps its filter around RitsuLib's check, which stopped the RitsuLib fix from working with both installed. • ZoneTheSpire: Zone filters "Bugged" cards out of the list of every power, relic and card in the fight. The Bugged check is faster, and the filter is skipped until a card in the fight actually gets Bugged. • Downfall: The Echo check on card titles asked every power and relic in the fight for the card's keywords. Now it reads the card's own keywords. • Runesmith2: Element icons were cleared on every card refresh, even when already clear. Now already-clear icons are skipped. • HoldYourTurn: The hand cost check rebuilt the full list for every card in hand. Now the whole hand shares one list. • MintySpire2: The incoming-damage label recalculated every enemy's damage on every change, often many times per frame. Now at most once per frame. Multiplayer Tested in games where some players had the mod and some didn't, including a full seeded run, with no desyncs. Not everyone in the lobby needs it. For mod makers With Visual Studio 2022 installed, a Record button appears in the pause menu, under Settings. It records a performance profile of the game, engine and mods and opens it as a flame graph in your browser. While a recording runs, a Stop button with a timer shows in the corner. Recordings save to %APPDATA%\SlayTheSpire2\QuantumsOptimizations\profiles . Without Visual Studio the button doesn't show.

详情图片

条目信息

所属游戏
杀戮尖塔 2 (Slay the Spire 2)
创意工坊 ID
3843466765
文件名
3843466765.bin
文件大小
5.8 MB
最后更新
2026/11/22
内容版本
v1795335285-6acc77b84a84d496
作者与来源
由原作者发布于 Steam 创意工坊。本站不改变署名,作者信息与原始内容请以 Steam 原始页面 为准。